Product Features: MADE IN USA
Modern Dual Durometer EPDM Composite: We Reproduced The Profile Die Exactly As Your Original, In Other Words If You Held Up Your Original End Side By Side With Ours The Difference Is Almost Undiscernable. But Used A Modern Dual Durometer Rubber, This Means The Rubber Is Slightly Harder On The Inside Edge Where It Contacts The Edge Of The Window Trim, So There Is No Need For the Metal Insert The Factory Used. This Does Produce A Very Noticeable Difference Between Our Product And Your Original Piece As Ours Remains Very Flexible Not Rigid Like Stock But Fit & Finish Is Gauranteed!!
END TOOLING: Each Seal Will Arrive With Correct End Cutouts For Ease Of Installation So They Are Position Specific On The Car, Be Sure To Order The Correct One For Your Needs. Factory Never Offered Them With The End Tooling, Which Meant You Would Recieve 1 Straight Piece That Was Extra Long And you Needed To Cut Out The Complicated Reliefs Yourself To Fit Into The Trim On The Door (AS SEEN IN IMAGE)You Could Potentially Ruin A Very Expensive Part.
Felt Flocking: We Electrostatically Bond Our Felt Flocking To The Rubber Same As Factory (AS SEEN IN IMAGE)
Installation Instructions: Each Seal Comes With Detailed Installation Guide So You Can Accomplish The Job Quickly And Properly
Low Temp VHB Double Sided Tape Included: We Are Including A Roll Of Very High Bond Double Sided Tape (JUST AS FACTORY USED) With Your Seal. This Tape Was Applied To The Inner Channel Of the Chrome Trim On The Door To Help Bond The Fine Outer Edge Of The Rubber Into The Little Outer Trim Groove.
Fits: (Right Front Door Outer)
Cabriolet 1990-1993 (1979-1989 Version Is Also Available Order Accordingly)
