Complete Stainless Steel Brake Hose Kit Hard and S/S Flex Lines W/Rear Drum Only

Mk1 Originals introduces our new line up of direct replacement CNC Bent/Molded Stainless Steel Hard Brake lines and complete brake line kits, all tubes are formed using a state of the art CNC tube bender. These lines make the job of replacing, repairing or upgrading your brake system a much less arduous task. If you have ever spent your time trying to properly flare and bend steel brake lines then you learned it is truly a skill not all can do. This is why we took on the challenge of data basing and CNC programming all the necessary lines for your Mk1,  so you can spend more time in the driver's seat and less time with 4 wheels in the air.

MADE IN USA

All fittings used in our assemblies are made by the original OEM in Germany then assembled here from Stainless steel line is from the USA.

All Mk1 Originals tubes and lines meet or exceed DOT, TUV and ISO standards, all lines are Metric Bubble 45 degree double flared to original specifications.

Includes CNC formed Complete Stainless Steel Hard Line kit and All 4 Stainless Braided Flex Hose For Front Caliper and Rear Brake Drum.

This Deluxe Kit Includes (As Seen In Illustration)

a) Complete Set of S/S Hard Lines

b) Complete Set Of Front & Rear S/S Braided Flex Lines 

c) New Assembly Clips For Points Where The Hard Lines Mate To Flex Lines

c) 10 Epdm Rubber Dual Brake Line Body Grommets For Undercarriage 

e) 6 Silicone Rubber Single Line Body Grommets For Various Mounting Points On The Body

f) 1 Roll 3m Abrasion Tape For Wrapping Around Dual Grommets To Prevent Where At Body Contact Clamps Of Undercarriage

FITMENT: PLEASE READ THESE VERY IMPORTANT FITMENT NOTES BEFORE ORDERING!:    (PROPORTIONING VALVE LINE NOTE) Fits US Built Rabbit & Pickup With Bendix Brake Booster And Proportioning Valve Mounted to Front Suspension Frame Only. Further, Early Master Cylinders For This System Came With One Of Two Mounting Positions For This Line (a) On The Side Of The M/C Or (b) Underneath The M/C. Current Available Versions Of This M/C Will Come With Both Options And Include Plugs For The Unused Outlets. If You Have Replaced Your Old M/C In the Last Decade This Is Not A Big Concern. This Line Is Intended For SIDE MOUNT. Be Sure To Verify This On Your M/C Before Ordering. 6' LONG REAR LINE NOTE: Fits US Built Rabbit Only, With Bendix Brake Booster And Proportioning Valve Mounted to Front Suspension Frame. Further, There Were 2 Routing Versions Of This Line Where The Line Clamps To Underside Of Floor. One Runs On The Inside Of The Frame Rail and One On The Outside. This Is The Outside Version. Some Rabbit Came Fitted With Mounting Clamps In Both Positions If Your Car Has Both Or Just Outside, This Line Is Correct . If Your Clamps Run On The Inside Of The Frame Brace This Will Not Fit)

Fits: 

US Built Rabbit 1980-1984 (W/ Rear Drum Brakes)

Some Images may differ slightly from actually line you receive. We are updating images soon, be sure to utilize fitment chart below and you will receive the correct line for you application.