(1) Rear License Panel Rebuild Kit
If you have tried to find matching hardware to this plate assembly then I am sure you found out how hard it is in the USA to find the correct fasteners for something like this kit. We did all the homework on this for you and brought over all the correct Deutsche Industrie Normen (DIN) fasteners to help make your restoration time spent in the garage as opposed to online or searching fruitlessly in the local hardware store.
I took the liberty of adding rubber washers to the kit the factory did not provide them but they are excellent at reducing vibration from the plate as well sealing against the nut so next time you need to remove the plate you can just twist off the nut.
To rebuild the panel properly without damaging the expensive plastic frame you will need remove it from the decklid, so I have also included the correct plastic expanding rivets to reinstall when your through.
Each kit Includes:
All the correct Zinc coated factory specified Deutsche Industrie Normen (DIN) fasteners to rebuild one rear license plate panel. So if your just replacing or getting ready for the concourse the kit is correct.
4 zinc coated carriage bolts
4 zinc coated spring lock washers
4 Epdm water sealing vibr. dampening washers
4 Closed end Zinc Coated Extrusion Nuts
5 Black plastic expanding rivets to attach the panel back to the decklid when your done.
