Mk1 Originals introduces our new line up of direct replacement CNC Bent/Molded Stainless Steel Hard Brake lines and complete brake line kits, all tubes are formed using a state of the art CNC tube bender. These lines make the job of replacing, repairing or upgrading your brake system a much less arduous task. If you have ever spent your time trying to properly flare and bend steel brake lines then you learned it is truly a skill not all can do. This is why we took on the challenge of data basing and CNC programming all the necessary lines for your Mk1, so you can spend more time in the driver's seat and less time with 4 wheels in the air.
MADE IN USA
All fittings used in our assemblies are made by the original OEM in Germany then assembled here from Stainless steel line is from the USA.
All Mk1 Originals tubes and lines meet or exceed DOT, TUV and ISO standards, all lines are Metric Bubble 45 degree double flared to original specifications.
Includes (1) CNC formed Proportioning Valve to Passenger Rear Stainless steel hard brake line. (As Seen in the Illustration)
FITMENT: PLEASE READ THIS IMPORTANT FITMENT NOTE!: ( Line Fits US Built Rabbit Only, With Bendix Brake Booster And Proportioning Valve Mounted to Front Suspension Frame. Further, There Were 2 Routing Versions Of This Line Where The Line Clamps To Underside Of Floor. One Runs On The Inside Of The Frame Rail and One On The Outside. This Is The Outside Version. Some Rabbit Came Fitted With Mounting Clamps In Both Positions If Your Car Has Both Or Just Outside, This Line Is Correct . If Your Clamps Run On The Inside Of The Frame Brace This Will Not Fit)
US Built Rabbit Pickup 1980-1984
Some Images may differ slightly from actually line you receive. We are updating images soon, be sure to utilize fitment chart below and you will receive the correct line for you application.
IMPORTANT FREIGHT INFORMATION FOR THIS LINE:
THIS LINE IS OVER 6 FEET IN LENGTH AND SHIPS OVERSIZE FREIGHT. IT MUST BE SHIPPED WITH A "SHIPPING BEND" IN ORDER TO FIT THE 6' BOX. EACH BEND WILL HAVE A TAG AND YOU WILL SIMPLY STRAIGHTEN THIS SECTION BETWEEN THE TWO TAGS AGAINST A FLAT SURFACE BEFORE INSTALLING.
